ElecGear 8X FU 2.3K Trimmer Potentiometer Replacement for PS5 DualSense Controller, Trim Pot Resistor Thumbstick Module 3pin Sensor for Favor Union Analog Joystick


$9.98

FU 2.3K Potentiometer
8x OEM substitute variable resistor was made by Favor Union (FU). It matches analog joysticks made by FU. This 2.3K ohm model was present in some PS5 DualSense controllers

1. Solve most of joystick issues:
80% probabilities of joystick issues have been brought on by the potentiometer. In one other phrases, the rotary mechanism and the tactile switches should not the issue. You can merely change the aspect potentiometer sensor alone to resolve many of the joystick issues

2. Additional resistors included:
Complicated shifting mechanism and day by day put on and tear could cause drifting, and even new potentiometers can’t be 100% balanced. Calibrating in controller settings may not work. Please solder a number of paralleled resistors at the wrong way towards drifting

Compatibility Notes:
1.FU potentiometers don’t work with joysticks made by ALPS
2.FU sensors are available two completely different resistance values. This 2.3K model was printed 2K3. Please ensure that the resistance worth is about 2.3K ohm earlier than ordering
3.Please select 10K model for some PS3, PS4, Nintendo Switch, Hori, PDP, BDA (Power A) controllers with FU joystick inside

[FU 2.3KΩ Potentiometer] – The substitute variable resistor was made by Favor Union (FU). It matches analog joysticks made by FU. This 2.3K ohm model was present in some PS5 DualSense controllers
[Compatibility] – FU sensors are available two completely different resistance values. This 2.3K model was printed 2K3. Make certain the worth is round 2.3KΩ earlier than ordering. (Be seen: Choose 10KΩ model for some PS3, PS4, Nintendo Switch, Hori, PDP, BDA (Power A) controllers in case you discovered FU joysticks inside. The potentiometer in orange made by FU just isn’t suitable with joysticks made by ALPS, whereas 60% of PS5 controllers use ALPS joysticks.)
[Additional Resistor] – Complicated shifting mechanism and day by day put on and tear lastly brought about drifting. Even new sensors can’t be 100% balanced. Calibrating in controller settings may not work. We packed 10x correction resistors to resolve the potential drawback in {hardware} degree. Solder one or two paralleled tiny resistors onto the potentiometer at the wrong way towards drifting. It will assist appropriate 3 to five levels drifting
[For most joystick problem] – The potentiometer sensor must be changed when the controller has the issue of creeping, stuttering, a blind spot, a useless spot, a useless zone, or it would not middle after years of wear and tear and tear. De-soldering the unit with solely 3Pins shall be loads simpler than changing the complete joystick with as many as 14 prongs
[Reminder of Replacement] – Use a pair of pliers to separate the issue sensor off the joystick module. Try to switch the wiper first, see if it really works. De-solder the sensor off the PCB. A metallic decide helps to clear the holes. Soldering the brand new unit in is a breeze. Remember to calibrate the brand new management sticks in settings

Category:

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “ElecGear 8X FU 2.3K Trimmer Potentiometer Replacement for PS5 DualSense Controller, Trim Pot Resistor Thumbstick Module 3pin Sensor for Favor Union Analog Joystick”

There are no reviews yet.